Can you lengthen a throttle cable?

Can you lengthen a throttle cable?

Re: Lengthen a throttle cable that’s just a smidge too short if it’s just the cable itself that’s too short inside the hosing, sometimes you can remove or recoup enough length by using shorter barrel adjusters both at the throttle but often more easily at the top of the carb.

How do you free up a sticky throttle cable?

Pour penetrating oil into the cable (Photo 1). Grab the inner cable with pliers and work it up and down to loosen it. When the cable moves freely and all the penetrating oil has drained out, squirt silicone lubricant into the funnel to keep the cable sliding freely. Reinstall the cable (Photo 2).

How much slack should a throttle cable have?

Most motorcycle manufacturers recommend about 2 to 3 millimeters of throttle free play, but over time the cables will stretch and settle into their housings and you’ll end up with more slack.

How do you fix a sticky throttle stick?

How to Fix a Sticky Throttle on a Dirt Bike – Cheap, Easy, and Fast Solution

  1. 2.1 Remove Throttle Tube.
  2. 2.2 Wipe Down Handlebar and Throttle Tube.
  3. 2.3 Scotch-Brite Handlebar and Throttle Tube.
  4. 2.4 Apply Small Amount of Grease.
  5. 2.5 Tighten Bolts and Test.

What happens if your throttle cable snaps?

When the gas pedal is pressed, the cable is pulled and opens the throttle. If the cable breaks, or comes out of adjustment far enough, it can affect the drivability of the vehicle to the point where the car will not be drivable until the problem is addressed.

What kind of throttle cable does Lokar use?

Exceptionally smooth throttle function comes from Lokar’s line of Hi-Tech throttle cable kits that tie the throttle pedal and carburetor together for a slick demonstration of form and function. Lokar throttle cable kits are available in braided stainless, black stainless, or with a black housing.

What do you need for a Lokar Mustang?

Soak the screw with WD-40 in advance. Lokar Performance Products offers classic Mustang enthusiasts a better bolt-on throttle pedal system you can install in an afternoon and be out cruising by nightfall. There are two items you need to purchase: the billet throttle pedal assembly and Hi-Tech throttle cable package.

Where does the throttle cable go on a 1969 Mustang?

If you’re working with a 1969-70 Mustang with the suspension pedal and cable system, Lokar’s billet throttle pedal bolts to the firewall where the factory pedal assembly was, which means you don’t even need a helper for this one.

Can you use Lokar pedal pads on a corvette?

Machined to fit over the stock Corvette steel brake/clutch pads. Available in brushed or black finish. Replace your worn out Mustang hard throttle linkage and pedal pads with Lokar’s Mustang Throttle Assembly and Pedal Pads. Designed as a direct replacement for the stock assembly when paired with Lokar Throttle Cable and Brackets.