Does Firex still make smoke detectors?

Kidde acquired the manufacturer of Firex branded products in 2009 – Invensys Controls no longer manufactures or supports these products. If you own any of these products, they should be replaced with a current Kidde model.

How do you replace a hard-wired smoke detector?

The steps are pretty simple:

Turn off the power.
Give your smoke alarm a twist to loosen it.
Disconnect your smoke alarm from the wiring harness.
Loosen the screws that hold the mounting bracket in place.
Remove the mounting bracket.
Disconnect the old wiring harness from the existing wires.

Do hard wired smoke detectors go bad?

A. Your detectors are overdue for replacement, according to the National Fire Protection Association, which recommends that you replace detectors when they’re 10 years old. You can replace hard-wired detectors yourself, if you can reach them and if you have sufficient skill to replace a light fixture.

How do you dispose of Firex smoke detectors?

Smoke detectors typically fall within two categories: photoelectric and ionization. When it comes to disposal, old photoelectric detectors can be safely put in the trash, so long as you remove the battery first.

Is it hard to replace a hard-wired smoke detector?

Replacing a hard-wired smoke detector is almost as easy as replacing a battery-powered version. New alarms are inexpensive. Turn off the power at the main electrical panel and disconnect the old alarm (Photo 1). Check to make sure the power is off with your voltage tester.

How do you fix a smoke alarm?

But once you’re sure it’s a false alarm, your approach should vary based on the type of power your smoke alarm uses. Your first step is to find the device that’s going off and reset it by pressing and holding the reset button. If that doesn’t work, take the smoke alarm down. If you can, remove the batteries.

How often do you need to replace smoke detectors?

Smoke alarms should be replaced every 10 years. CO detectors should be replaced every 5 to 7 years. With a combination unit, you are either replacing the smoke alarm too soon, or relying on a CO detector that is past its expiration date.

Why is my fire alarm going off for no reason?

A fire alarm going off for no reason could be an indicator of faulty wiring or a defective circuit. Many newer alarms also offer additional options such as strobe lights (for low-visibility situations) and built-in carbon monoxide detectors .

Why does a fire alarm keep going off?

Alternative Answer: Move Your Detector. There are all kinds of reasons fire/smoke alarms will go off when you’re cooking. Sometimes, it’s just flat-out smoke. Other times, atomized fats or even steam will be detected as smoke. Some detectors will also detect heat, and it’s really easy to generate excess heat near the ceiling when cooking.