How do I change the toner on my HP Neverstop laser MFP 1200w?

By Lexie Tanner 4 years ago

How do I change the toner on my HP Neverstop laser MFP 1200w?

Lift the scanner to access the reload port. Slide open the reload port cover. Remove the cap and ring from the Toner Reload Kit. Insert the Toner Reload Kit into the reload port, and then rotate it clockwise 180 degrees or until it stops.

How do I open my HP LaserJet 1200?

HP LaserJet 1200 Removing All of the Covers Instructions

  1. Open the toner cartridge door.
  2. Pull out on the notch (callout 1) on the back of the cover.
  3. Rotate the cover away from the printer.
  4. Open the straight-through output door.
  5. Remove two screws (callout 1) from the back of the printer.

How do I print a test page on HP LaserJet 1200?

The LaserJet 1200 doesn’t have much of an operation panel. There’s just one gray button and a couple of lights. To print a configuration page, hold down the gray button for about three seconds, then let go. The upper LED (the green one) should start flashing, and the configuration page will print out.

How do you open the HP Neverstop laser MFP 1200a?

Step 1: Remove jammed paper

  1. Remove all paper from the output tray.
  2. Lift the scanner, and then open the top cover.
  3. Using the handle, pull the imaging drum up and out to remove it, and then set it aside.
  4. Remove the input tray cover.
  5. Remove the stack of paper or envelopes from the input tray.

How do you replace toner cartridge on HP printer?

To replace the toner cartridge, open the scanner assembly and top cover, remove the old toner cartridge, and then install a new one. Lift the scanner assembly. Open the top cover. Remove the toner cartridge. Remove the new toner cartridge from the package. Place the used toner cartridge in the bag for recycling.

Where is the HP LaserJet 1200 service located?

HP LaserJet 1200 Series Service Hewlett-Packard Company 11311 Chinden Boulevard Boise, Idaho 83714 U.S.A. Copyright Information © 2001 Hewlett-Packard Company All Rights Reserved. Reproduction, adaptations, or translation without prior written permission is prohibited except as allowed under copyright laws.

Where is print carriage on hp PSC 1200?

The power must be turned on to the all-in-one or the print carriage will not come to the center. Locate and open the print cartridge access door on the front of the unit, just above the output tray. The print cartridge carriage will move into the middle of the access area.

How to change ink cartridge on hp PSC?

Press down gently on the top of the old ink cartridge to release it from the print carriage. Remove the new print cartridge from its packaging and remove the protective tape from the cartridge as shown in Figure 2. Do not touch the gold-colored contacts.