How do I reset my radio controlled clock?

How do I reset my radio controlled clock?

Radio-Controlled (MSF) Clock

  1. Insert a new AA battery.
  2. Press Reset button at the back of the clock, the clock hands will go clockwise and it will automatically set itself to the correct local time.

Do DAB radios change time automatically?

If the broadcast is not found on the hour check (e.g. the multiplex is off air), the radio will keep running its software clock until the multiplex reappears, and once it reappears the radio will automatically change its clock to meet the clock broadcast time to the nearest minute.

Why does my atomic clock keep changing time?

If the atomic radio controlled clock is off by one or more hours, it probably has to do with the time zone setting. Other atomic wall clocks may allow the selection of any time zone, even time zones that are outside the WWVB coverage area. When purchasing a clock, make sure that it can display the correct time zone.

How to reset the acctim radio controlled clock?

RESET button – Push & hold for 3 seconds, the clock will reset, after a few moments the hands will move to the 12 o’ clock position & start the signal receiving mode again.

Can a radio controlled clock be set to the exact time?

When the clock is exposed to the WWVB signal it will automatically set the hands to the exact time. Our Rwave, Atomic, Radio Controlled clocks do not receive or process radio controlled time signals from Germany’s DCF 77, Japan’s J Ga AS, or England’s MSFs atomically regulated transmitters.

How do you set an atomic clock manually?

Atomic Clocks may also be set manually and be very accurate. Simply insert the battery, press your time zone and then press the flap just above the left side of the battery. Hold until you reach the correct time and then release. Your clock is now an accurate quartz clock until it will find the signal.

How to change the time on a clock?

1 Take the battery out of the clock. 2 Press the manual time setting tab on the back of the clock 15 times. 3 Put the battery back into the clock. 4 The clock will go to 4:00, 8:00, or 12:00 and stay there while waiting for the signal.