How much horsepower does a 304 have?
How much horsepower does a 304 have?
The 304 has a displacement of 304 cu in (5.0 L), which produced 210 hp (157 kW; 213 PS)(gross rating) in 1970-71 and was built starting in 1970.
Is 304 a good engine?
ya, the 304 is a good engine, reliable. but old, less horsepower than the 258 straight six.
Who made international 304 engine?
International Harvester Company
1969. The V-304 was one of three “SV” (for Small V-eight) engines that debuted in 1959 for Light and Medium Duty International truck use in 266, 304 and 345 cubic inch displacements….V304 Engine for Scout 800A.
| Image ID: | 111022 |
|---|---|
| Creation Date: | circa 1966 |
| Creator Name: | International Harvester Company |
| City: | |
| County: |
How can you tell the difference between a 304 and a 345 engine?
Measure across your valley pan, from bolt to bolt. The 345 is wider than the 304, so if yours is a 345 the unknown engine should be the same measurement. If it’s less, it’s a 304 or 266, if it’s the same it could be a 345 or 392.
How much horsepower does a AMC 360 have?
Power Outputs For instance the 1970 and 1971 360 with a two-barrel carburetor had 245 horsepower at 4,400 rpm and 365 pound feet of torque at 2,600 rpm, while 1972 and later versions had 175 horsepower at 4,000 rpm and 285 pound feet of torque at 2,400 rpm.
How much horsepower does a AMC 401 have?
The practical limit of the plebian AMC 401 is about 500 hp at 7,500 rpm. The main caps will begin to walk above that, so limit these engines tohealthy street mills if you want to keep the price down and use stockparts.
Are AMC 360 engines good?
The AMC 360 is a very good motor actually. Super easy to work on. Performance parts are few and far between, so when you do find them, they can be expensive.
How do I know if I have AMC 304?
It should be on both sides of the block below the exhaust manifolds. Look on the block, just below the exhaust manifold on the drivers side. It will say 304, 360 or 401 if it’s an AMC but only the 304 was available in a CJ.
Who made the engine for the International Scout?
Although the Scout was occasionally equipped with engines manufactured by American Motors, all Scout V-8s were manufactured by International, so the International 304 cubic-inch is not to be confused with the American Motors’ 304 with the same displacement.
What engines came in international scout?
Scout 800
| International Scout 800 | |
|---|---|
| Engine | 152 cu in (2.5 L) Comanche I4 196 cu in (3.2 L) I4 232 cu in (3.8 L) I6 266 cu in (4.4 L) V8 |
| Chronology | |
| Predecessor | International Scout 80 |
| Successor | International Scout 800A |
How do I know what international engine I have?
Look for the distributor at the front of the engine. The distributor has a plastic cap with wires running to the individual spark plugs at each cylinder. All International V-8s have the distributor located at the front of the engine, whereas most V-8 distributors are located towards the rear of the engine.
How do I identify my scout engine?
Check on the right side of the engine towards the front, on the side of the block there is flat spot about the size of a domino, just below the cylinder head and exhaust manifold. The engine size is stamped in this location.