How to fix E20 error on washing machine?

By Lexie Tanner 4 years ago

How to fix E20 error on washing machine?

Resolution:

  1. Ensure correct position of the drain hose.
  2. Ensure correct drain height.
  3. Clean the pump and filter.
  4. Check for blocked drain.
  5. Check the drainage hose for possible kink or twist.
  6. Use less soap powder.
  7. Switch off the power to the machine.
  8. Contact an Authorized Service Centre.

What is an E20 error?

AEG error E20, E21, E22, E23, E24, E25, E32, C2, or F2. Your AEG washing machine doesn’t drain the water. The drum may be full of water. This can be due to a clogged drain filter or another problem with the drain. Otherwise the washing machine must pump up the water too far.

How do I reset my lavamat washing machine?

To reset this you need to turn the dial to off. Press and hold the start button and the button to the left of it. Keep them held in and turn the dial 1 click clockwise. Once the screen starts to flash let go of the buttons.

How to drain aeg lavamat?

Turn off the appliance. Open the door to the fluff filter and place the drip tray underneath. Empty any water out of the machine by opening the drain hose next to the filter. Remove the filter by turning it anti-clockwise (several times firmly by hand).

What is E20 on my washing machine?

Appliance displays error code E20, E21 or C2 – or emits 2 beeps / 2 flashes when your machine has detected that the drum of the machine will not drain.

How do you manually drain a washing machine?

If not, follow these steps:

  1. Step 1: Turn off the power and lay down towels.
  2. Step 2: Locate the drain hose at the back of the washing machine.
  3. Step 3: Drain the water.
  4. Step 1: Turn off the power and lay down towels.
  5. Step 2: Locate the drain hose.
  6. Step 3: Drain the water.
  7. Step 4: Scrub the filter.

How do I reset the code on my AEG washing machine?

You have to run the “test” cycle. With the switch in the off position, hold in the Pre wash & soak button and then turn the rotary knob to gentle (or short) spin. Presumably this should run a short test sequence and clear the error.

How do I reset my AEG 8000 washing machine?

Resolution

  1. 9000 series washing machine. In the programme list screen, tap on the shortcut to enter the setting menu.
  2. 8000 series washing machine.
  3. 6000 series washing machine. press and hold the and the buttons for at least 10 seconds simultaneously until the second acoustic signal.

How do you drain fluff from washer and dryer?

If your clothes still have any fluff on them afterwards, you can remove it with a fluff remover. Using too much soap can sometimes produce a fluff-like appearance on the surface of fabrics. You should therefore always add the right amount of detergent in accordance with the detergent manufacturer’s instructions.

How do you drain a washing machine that won’t spin?

What to Do When Your Washing Machine Won’t Drain

  1. Perform a Master Reset. Unplug your washer for about one minute.
  2. Test the Lid Switch Assembly.
  3. See if the Drain Hose is Kinked.
  4. Check the Drain Hose or Pump for Clogs.
  5. Clean out the Coin Trap.
  6. Check the Water Level Control.
  7. Schedule Washing Machine Repair.