Will Apple replace the bottom of my MacBook?

Will Apple replace the bottom of my MacBook?

3 Answers. First Apple has a repair policy when the bottom cover is replaced. The servicer is required to note the original systems S/N on the inside of the lid in permanent marker. So I would recommend you do that so your system is following the SOP.

When was the MacBook A1342 made?

2010
Apple Macbook A1342 (2010) – 13.3 inches – Intel C2D – 4GB DDR2 SO-DIMM – 250GB 2.5h SATA (Renewed)

What is a MacBook Pro unibody model?

A “unibody” laptop is a laptop computer that uses a single piece of metal or alloy for the body and screen enclosure. While primarily used to refer to Apple’s MacBook Pro line, different laptops from PC manufacturers like HP also qualify.

What was the last unibody MacBook pro?

The “Late 2008/Unibody” 13-Inch MacBook and 15-Inch MacBook Pro were replaced by the “Mid-2009” 13-Inch MacBook Pro and 15-Inch MacBook Pro, respectively, on June 8, 2009.

What MacBook came out in 2009?

What is a non unibody MacBook?

MacBook Pro laptops make up the higher-end models of MacBook computers. ‘Unibody’ computers have a case that is made up of a single sheet of aluminum. These computers are non-unibody, so their cases are made of several pieces. This theoretically makes it easier to take them apart and repair the insides.

How do I know the model of my MacBook?

Here’s how to find your MacBook’s model:

1. On your MacBook, go to the Apple menu (upper-left corner) > About this Mac.
2. In the window that pops up, you’ll see a serial number. Highlight it and copy it.
3. Head to Apple’s Check Coverage page and paste the serial number.

Does Apple still support mid 2012 MacBook Pro?

Apple will soon move another MacBook to the official “obsolete” list, a list where old Apple products go out to pasture. According to a note obtained by MacRumors today, Apple will move this computer to the “obsolete” list as of June 30, 2020. …

What is the maximum RAM for a MacBook unibody A1342?

Apple says 4GB is the maximum RAM for a MacBook Unibody Model A1342. Has anybody tried installing 8GB in it? I’m hoping the motherboard is similar enough to the 13″. MacBook Pro to support 8GB.

Where is the A1342 model number on a MacBook?

If you’re not sure whether or not you have a White “Unibody” MacBook or an earlier system, these models can be collectively identified by the A1342 Model Number on the gray rubber bottom of the notebook toward the hinge in tiny type. However, this identifier is not unique enough to determine actual maximum RAM capacity.

Is the bottom of the new MacBook unibody non slip?

Non-slip coating covering the bottom panel. The case revision also allowed Apple to update the aesthetics on the new Macbook. Its contoured edges fit right in with the rest of the unibody lineup. FireWire is gone! If you need FireWire, now only a MacBook Pro will do.

What’s the model number of the White MacBook Ram?

Please note that this Q&A explains how to upgrade the RAM in the White “Unibody” MacBook models shipped from 2009-2010 (model number A1342 ).