How do I setup my rocket M2 as an access point?

By Lexie Tanner 5 years ago

How do I setup my rocket M2 as an access point?

Steps to configure UBNT Rocket M2 as Access Point Mode

  1. Open the browser in your system or laptop and type the IP address of the UBNT Rocket M2 router.
  2. And then hit the enter button.
  3. Then you have to enter the default username and password.

How do you reset a Ubiquiti Rocket M2?

Reset Button To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the Rocket is already powered on. Power The Power LED will light green when the device is connected to a power source.

What is Rocket M5?

The Rocket M5 from Ubiquiti Networks is a 5GHz Hi Power 2×2 MIMO AirMax TDMA Basestation. This high power radio features a rugged outdoor design and enhanced receiver performance. The Rocket M5 is capable of extremely long range performance of up to 50+ km and speeds exceeding 150 Mbps.

What is Point-to-Multipoint topology?

The Point-to-Multipoint topology (also called star topology or simply P2MP) is a common network architecture for outdoor wireless networks to connect multiple locations to one single central location.

What’s the range of a Ubiquiti bullet m2?

Ideally a more comprehensive WiFi test should be conducted with JPerf/IPerf, but here I’d prefer to demonstrate some basic stats that can be collected on your home network without requiring any extra tools. The Bullet M2 had a stable range of about 150m through a typical suburban non-LOS environment.

Can a Ubiquiti rocket mount on an Airmax antenna?

To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is already powered on. The Rocket is designed to mount directly onto a Ubiquiti airMAX RocketDish™ antenna for Point-to-Point use or an airMAX Sector antenna for Point-to-MultiPoint use.

What kind of radio does the Ubiquiti bullet use?

The Ubiquiti Bullet series are a high powered 2.4GHz or 5.8GHz outdoor radio (denoted M2 or M5 respectively). With a cylindrical “bullet” shaped form factor the device is designed to sit inline between an Ethernet cable input and a WiFi antenna output.

What do you need for Ubiquiti Nanostation m2?

…What you need… Ubiquiti NanoStation M2 – This is a commercial grade, weather resistant piece of network gear. As such, there are no wizards or other hand-holding to configure it. Fortunately, setup is pretty straightforward. Ubiquiti AirGateway – If you ONLY have wireless devices you want to connect, you can add one of these to your setup.