How do you tighten a bar end?

Insert the bar end. Then, use a flat head screwdriver and wedge the plastic piece 6 in. Once 6 is in, push the bar end flush and tighten the screw.

Are bar end shifters indexed?

What are bar end shifters? These are gear shifters that sit at the end of your bars, whether that’s drop or straight bars. They have levers that you click one way to shift up and one way to shift down, so are also indexed.

Why do people use bar-end shifters?

Bar-ends have a friction option. By switching the rear shifter out of index and into friction, it’ll work on cassettes or freewheels with any number of cogs. So, if you trash your rear wheel and have to buy an old one with a 6-speed freewheel at a flea market in Murdo, SD, you’ll still be able to ride.

Are bar-end shifters any good?

When compared with integrated brake/shift levers they are inexpensive, simple and reliable; all prized traits in touring gear. For my money, they’re the flat-out best shifter for a drop-bar touring bike.

Are microSHIFT shifters any good?

The shifter shape is fairly good and they felt just fine on long rides. Quality wise, they were right in line with the 105 stuff, maybe even a little better. felt also puts the microshift shifters on some lower-end bikes with sora components. not the same shifters as the 105 bikes (9 spd vs.

How do you use bike shifters?

To operate the shifters you push the lever sideways until you hear a click. For most mountain and hybrid style bikes with flat bars, you shift the gears by using set paddles that you operate with your thumb. Some bikes operate with “grip shifters”, or a dial that is located to the inside of where you place your hands.

How do you install a shift lever on a bar?

After securing shift lever body to handlebar, assemble shift lever parts to body and secure lever screw with screwdriver (Figure 6). Install gear wire through lever and into housing. Housing must fully seat into lever body. Secure housing to handlebars with tape.

How do you tighten a Shimano bar end shifter?

Position the shifter so that the cable housing stop, the small hole in the body of the shifter, is at the bottom. Fit a 6 mm hex wrench into the hole in the center of the Shimano bar-end shifter. Turn the wrench clockwise to tighten the shifter in place.

How does a bar end shifter work on a car?

Bar end shifters mount internally to the handlebar using an expansion plug. Handlebars typically must have an inside diameter of approximately 19-21mm. The shifter body and bolt are made with a cone shaped end that push into a set of wedges (Figure 3). The wedges then expand and tighten inside handlebar. Figure 3.

Where does the hex wrench go in a bar end shifter?

To access the mounting bolt, it is necessary to remove the shift lever. Insert a 6mm hex wrench through the lever body and into the back of the mount bolt. The hex wrench fits into the back of the mounting bolt.